Skip to content
Glossary

What Is Backfeeding?

Backfeeding is the flow of electricity through a circuit in a direction opposite to its usual supply path. In a generator system, it can occur when generator power reaches wiring normally supplied by the utility. That wiring may include the home's electrical panel and the utility lines connected to it.

Quick Facts About Backfeeding

Category
Electrical power flow
Applies to
Generator and utility connections
Common confusion
Reverse flow versus an electrical fault
Also called
Electrical Backfeed
Often discussed with
Generator Repair, Electrical Troubleshooting

Key Takeaways About Backfeeding

  • Power can travel toward the utility connection.
  • A transfer switch separates supply paths.
  • Reverse power flow isn't always a fault.

How Backfeeding Works

Hands connect red and black wires inside an open electrical panel outdoors

Backfeeding follows any connected path that lets power flow toward another supply. A generator sends power into the home's wiring when it runs. The available path determines where that power travels.

Related glossary terms: Transfer Switch, Electrical Panel, Circuit Breaker.

A transfer switch changes the connection between the home and its power sources. It separates the utility supply path from the generator supply path during generator operation. A panel may also use an interlock that controls which supply breaker can be on.

The direction of power flow alone doesn't tell you whether a connection is faulty. Some electrical equipment is designed for power to flow in either direction. The concern in a generator setup is where the power can reach through the connected wiring.

A person uses test probes on an open electrical panel beside a warning sign on a house exterior

From the Center Electric Service team

When we repair a generator, we look at how its output connects to the home's wiring. We check the transfer equipment and related connections for faults that could affect separation from the utility supply. The generator itself is only part of that power path.

Backfeeding in Practice: A Real-World Example

A Riverside homeowner's generator runs during an outage, but a faulty transfer switch leaves the utility connection closed. Generator power can then reach the utility wiring through the panel.

Related Terms

Transfer Switch

A transfer switch is an electrical device that selects a power source for connected circuits.

Electrical Panel

An electrical panel is a cabinet that distributes electricity to circuits throughout a building.

Circuit Breaker

A circuit breaker is an electrical protection device that stops current when a circuit draws too much power or develops a short circuit.

Service Disconnect

A service disconnect is a switch or circuit breaker that shuts off power from the utility to a building's electrical system.

Center Electric Service

Have Questions About Backfeeding?

Contact Center Electric Service for practical guidance on Backfeeding and related 24 hour electrician work in Riverside.

(951) 577-3540